• sales

    +86-0755-88291180

Raspberry Pi Zero WH (KIT F) User Guide

Instroduction

The Raspberry Pi Zero is half the size of a Model A+, with twice the utility. A tiny Raspberry Pi that’s affordable enough for any project!

Note: this is the original Pi Zero V1.3, for the new version with built-in WiFi, please check

Difference among Zero, Zero W, and the Zero WH

The Raspberry Pi Zero is the basic version of the Raspberry Pi Zero series without WiFi and Bluetooth functions. The Raspberry Pi WH has a wireless card featuring WiFI and Bluetooth functions. The Raspberry Pi Zero WH version has a pre-soldered 40PIN pin-header based on the Raspberry Pi W for easy use.

Raspberry Pi Features

  • Broadcom BCM2835
    • 1GHz ARM11 single-core processor
  • 512MB RAM
  • Micro SD card slot
  • Mini-HDMI port (1080p60 video output)
  • Micro-USB power
  • Micro-USB OTG port
  • 40PIN unpopulated GPIO header (compatible with A+/B+/2B/3B)
  • CSI camera connector
  • Composite video header
  • Composite reset header
  • Dimension: 65mm x 30mm x 5mm

Raspberry Pi Zero vs Raspberry Pi W

The Raspberry Pi W has a wireless card, which supports WiFi and Bluetooth.

1.3inch LCD HAT

Features

  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards
  • IPS screen, wide viewing angle, better display
  • High definition in small size
  • 1x joystick, 3x pushbuttons, handy and useful

Specification

  • Driver: ST7789
  • Interface: SPI
  • Display color: RGB, 65K color
  • Resolution: 240x240
  • Backlight: LED
  • Operating voltage: 3.3V

For more information about the 1.3inch LCD HAT, please refer to the wiki of the 1.3inch LCD HAT

UPS HAT (C)

Features

  • Onboard spring pogo pins for connecting with Raspberry Pi Zero series boards
  • Li-po battery recharge chip, with dynamic path management, more stable power supply
  • Voltage boost chip, providing regulated 5V power output
  • I2C bus communication, monitoring the battery voltage, current, power, and remaining capacity in real time
  • Multi battery protection circuits: over charge/discharge protection, over current protection, and short circuit protection, more safe and stable
  • Recharging indicator for monitoring the battery operating status
  • Comes with development resources and manual

Specifications

  • Output voltage:5V
  • Charger:5V
  • Control bus:I2C
  • Battery supported:803040 Li-po battery 1000mAh 3.7V
  • Dimensions:65 × 30mm
  • Mounting hole:3.0mm

For more information about the UPS HAT (C), please refer to the wiki of the UPS HAT (C)

General Tutorial Series