• sales

    +86-0755-88291180

Raspberry Pi Run a single course program User Guide

2. Run a single course program


If you want to run each routine separately, you need to close the process we have started up.

Temporary method:

This method will start the program after power-on again.

2.1 Input following command to check process.

ps -ef|grep RGB_Cooling_HAT


2.2 Input following command to close this process.

sudo kill -9 466


! Note: Everyone's process ID is different, please operate according to your actual process ID.

Permanent method:

This method will not start the program after power-on again.

Enter the following command:

sudo nano etc/rc.local

Add # sign before the following command:

Save and exit.

Next, you can run other program normally.

TAG: ESP32 Display NanoKVM-Lite Raspberry Pi 5 PD Power Cortex-A7 Arducam Jetson Raspberry Pi Pico 2 RP2350-Tiny/Tiny-Kit Super Mini Board RP2350A Raspberry Pi 5 PD Activation Raspberry Pi 1.54inch OLED Sipeed SLogic 4IN1 USB Logic Analyzer 80M / DAPLink / CKLink Debugger Tool / UART Module Raspberry Pi DS3231 ESP32 S3 R8 MP3 Board 2.8inch LCD TouchScreen Display Speaker/SD-Card/Battery/QMI8658-6-Axis-Sensor Gyroscope Sensor ESP32-P4 Smart 86 TV Box Development Board 4 inch 720x720 Display TouchScreen RS485 Relay Camera RJ45 ETH ESP32-S3 Development Board 4 inch LCD TouchScreen Display 480x480 RS485 /SHT20 /Relay For Arduino LVGL 86 TVbox ESP32-S3 Raspberry Pi 5 PCIe to M.2 SSD MAX9296 GMSL Camera Adapter Board 2-Ch High-Speed And Low-Latency Transmission For Jetson Orin Nano/NX ESP32 Portable Pendant Code